- #Zebra setup utility does not list z4mplus driver Pc
- #Zebra setup utility does not list z4mplus driver windows
When I assigned the Zebra printer the static IP, the print server tried printing the HP printer jobs from two years ago.Ĥ. When the old HP printer was removed, there were unprinted jobs in the queue on the print server.ģ. The static IP I was being used on a print server that had old print jobs queued.Ģ.
#Zebra setup utility does not list z4mplus driver windows
via ping the static IP using Windows command line.ġ. Intermittent connectivity to the zebra printer. Any incompatible job will hang your connection to the printer while your printer attempts to figure it out. If so kill the source of those print jobs. See which ones are hitting your static IP and verify that this is not on a print server bit banging your printer with print jobs. Or have your network guy catch the packets.Try using a couple different static IP addresses.With a pile of blank labels on the floor caused by the print server attempting to finish the queued jobs. Turned out to be a print-server that had a job queue for the IP address I used.
Maybe if enough of us switch to a different brand label printer, that would be enough to get Zebra's attention? Let's try it and find out. After all, I have 100+ other network devices that think my network is just fine. I fully expect the problem to spring up again and I'd prefer to have a reliable printer rather than one that needs VLAN's or extra network print servers to cover for their flaws. But don't worry Zebra, your reseller was happy to sell me a different brand, so I'm all taken care of now.Īnyway, even though they are currently working fine, I am replacing them. But, they referred me to a reseller instead who then became stumped. I would think that this information would be valuable to Zebra since it has happened to a few of us now, some having more affected Zebra printers than others. I could have dug into this more, used Wireshark, etc, but why? These printers are not that expensive and my time is extremely valuable. The theory I've seen that I think holds the most potential is these printers having sensitivities to something in the network environment - number of broadcasts, etc. The issue happened on two different print servers. The problem did go away after I rebooted servers, however, which includes 2008 R. The problem springs up on both of them at the same time when it does happen. The two Zebra GX420d's worked fine when connected directly to a laptop or on a small network with a switch and a laptop, so the hardware isn't failing. We also tried all the basics - firmware, drivers, cabling, IP conflicts, etc. Has anyone else had the same issue that was resolved or could anyone maybe think of something we are missing? We have tried everything suggested in the above thread and the steps taken in the original query but nothing makes any difference whatsoever. This thread describes the exact same issue we are having. They have been functioning perfectly until now and nothing has changed on our network that would cause this to happen. We have over a dozen Zebra GK420d label printers that constantly fall off our network for no apparent reason.
#Zebra setup utility does not list z4mplus driver Pc
If your network is small look for a malfunctioning pc or server that is sending out a lot of broadcasts. We solved the problem by putting the printers on a VLAN to separate them from the main network. We found that the printers are very sensitive to broadcast traffic. We have had this problem with the Zebra GK420t printers.